Epson S1D13504 ユーザーズマニュアル

Page 4

Vancouver Design Center

S1D13504

13504SHOW Demonstration Program

X19A-B-002-05

Issue Date: 01/01/30

PC platform: at the prompt, type 

.

Embedded platform: execute 

 and at the prompt, type the command line argument.

Where:

b=??

starts 13504SHOW at a user specified bits-per-pixel (bpp)
level, where ?? can be: 1, 2, 4, 8, 15, or 16

/a

automatically cycles through all video modes

/lcd

displays on the LCD panel

/crt

displays on the CRT 

/vertical 

displays vertical line pattern

/? 

displays the help screen

/noinit 

bypasses register initialization

• 13504SHOW cannot show a greater color depth than the display allows.

• The PC must not have more than 12M bytes of system memory when used with the 

S5U13504B00C board. 

• Follow simultaneous display guidelines for correct simultaneous display operation.

• To determine if the CRT will operate correctly when using a dual panel, refer to the “Maximum 

Frame Rates” table in the S1D13504 “Functional Hardware Specification,” document number 
X19A-A-002-xx.

• When editing in 13504CFG with CRT enabled and panel disabled, select “Single Panel” from the 

“Edit Panel Setup” submenu.

• When a CRT is enabled, the CRT settings will override the panel settings. If a panel is also used, 

the CRT timing values will have to be changed to more closely match the panel's timing.

• A CRT cannot show 15 or 16 bits-per-pixel.

• Do not attach a panel with a 16-bit interface to the S1D13504 when a CRT is also attached.

There are too many display devices attached to the HAL. The HAL can only manage 10 devices 
simultaneously.

A 13504 device was not found at the configured addresses. Check the configuration address using 
the 13504CFG configuration program.

The HAL was unable to read the revision code register on the S1D13504. Ensure that the S1D13504 
hardware is installed and that the hardware platform has been set up correctly.