Epson S1D13504 ユーザーズマニュアル
Page 20
Epson Research and Development
Vancouver Design Center
S1D13504
Interfacing to the Philips MIPS PR31500/PR31700 Processor
X19A-G-005-08
Issue Date: 01/02/02
5.5 S1D13504 Configuration
The S1D13504 latches MD15 through MD0 to allow selection of the bus mode and other
configuration data on the rising edge of RESET#. For details on configuration, refer to the
S1D13504 Hardware Specification, document number X19A-A-002-xx.
configuration data on the rising edge of RESET#. For details on configuration, refer to the
S1D13504 Hardware Specification, document number X19A-A-002-xx.
The partial table below only shows those configuration settings relevant to the IT8368E
implementation.
implementation.
Table 5-3: S1D13504 Configuration using the IT8368E
S1D13504
Pin Name
value on this pin at rising edge of RESET# is used to configure:(1/0)
1
0
MD0
8-bit host bus interface
16-bit host bus interface
MD1
See “Host Bus Selection” table below
See “Host Bus Selection” table below
MD2
MD3
MD4
Little Endian
Big Endian
MD5
WAIT# signal is active high
WAIT# signal is active low
= required configuration for connection using ITE IT8368E
Table 5-4: S1D13504 Host Bus Selection using the IT8368E
MD3
MD2
MD1
Host Bus Interface
0
0
0
SH-3 bus interface
0
0
1
MC68K bus 1 interface (e.g. MC68000)
0
1
0
MC68K bus 2 interface (e.g. MC68030)
0
1
1
Generic bus interface (e.g. MCF5307, ISA bus interface)
1
x
x
Reserved
= required configuration for connection using ITE IT8368E