FARGO electronic Pro-LX Laminating Card Printer/Encoder ユーザーズマニュアル
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0)
196
Resolving the DRAM Memory Error
Symptom: A DRAM Memory Error is displayed on the LCD display.
Step
Procedure
1
Reboot the Printer.
2
If the problem persists, remove the rear cover and ensure that the SIMM
(080016) is seated properly.
(080016) is seated properly.
3
If the memory module is not seated properly, remove the board and reinstall.
4
If the installation appears correct and the error persists, the SIMM (080016) on
the Main Print Board will need to be replaced.
the Main Print Board will need to be replaced.
Sensor Testing
Step
Procedure
1
Check the voltage to determine if a Sensor is working.
2
a. Test the voltage of each Sensor using ground (GRD = Chassis) to the
correct pin on each connector. See the Sensor Location and Voltages
table on the next page.
table on the next page.
b. Block a Slot Sensor with a card.
c. Cover a Reflective Sensor with a card.