Printronix T5000e Series ユーザーズマニュアル
Chapter 1
Adjust The Scanning Beam
28
Adjust The Scanning Beam
NOTE: Make sure the printer is on and the scanning beam is on. If
the beam is off, press the RESET button for less than 2
seconds to turn on the beam.
seconds to turn on the beam.
When the validator is first installed, the scanning beam may need to
be aligned with the two notches on the sides of the tear bar, as
shown in Detail A of Figure 12. When the scanning beam is
properly aligned it will line up with the two notches.
be aligned with the two notches on the sides of the tear bar, as
shown in Detail A of Figure 12. When the scanning beam is
properly aligned it will line up with the two notches.
Figure 12. Aligning the Scanning Beam
A
t5lsrlc2
June19,2000
June19,2000
A
Notch in Tear Bar
Scanning Beam