Printronix P7000 ユーザーズマニュアル
Chapter 4
HOST INTERFACE
94
For example, if the printer is printing a job from the serial port, and
then receives a second print job from the parallel port, the data from
the parallel port will “trickle” bit by bit into the printer buffer to
prevent a timeout error from being sent back to the host connected
to the parallel port.
then receives a second print job from the parallel port, the data from
the parallel port will “trickle” bit by bit into the printer buffer to
prevent a timeout error from being sent back to the host connected
to the parallel port.
The selected value is the time that the printer waits before getting
the next byte of data from the host. The Trickle Time value should
be less than the host time out value, but not too much shorter or
else the printer fills up its buffer too fast. This function is not
applicable for C/T hotport.
the next byte of data from the host. The Trickle Time value should
be less than the host time out value, but not too much shorter or
else the printer fills up its buffer too fast. This function is not
applicable for C/T hotport.
Dataproducts (Standard) Submenu
Dataproducts
Data Bit 8
PI Ignored
Data
Polarity
Resp.
Polarity
Latch Data
On
Prime Signal
TOF Action
Buffer Size
in K
Enable*
Disable
Disable
Enable*
Disable
Disable
Standard*
Inverted
Inverted
Standard*
Inverted
Inverted
Middle*
Trailing
Leading
Trailing
Leading
Disable*
Enable
Enable
Reset*
Do Nothing
Do Nothing
16*
(1-16)
(1-16)
* = Factory Default
Auto
Trickle
Disable*
Enable
Enable
Trickle
Time
1/4 sec*
1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
Off
1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
Off