Primera Technology LX400 ユーザーズマニュアル

2.  Nonstandard / Non-translucent Backing Material. Test the

unit with the label sample material that came with the

unit. If it prints correctly, your label stock may not be 

compatible. The label sensor needs to see the difference

between a label and a backing material by seeing through

the label stock for light variations. If it can not see through

the label, problems will arise. If you must use this type of

backing, try label stock that has a black mark on the back

to show where the label begins. You will need to change

the Sensor Type setting in the driver preferences to

Reflective.

3.  Improper Label Gap Distance. See Section 6 for label 

specifications.

4.  Page Size is Bigger than Label Stock Size. If the page size

set in the driver is larger than the actual label stock, ink

will be printed on the gaps and the sensor will start 

looking for a gap too late. This can cause label skipping 

or inconsistent print starting points. 

5.  Portrait / Landscape. If the Portrait / Landscape setting

does not correspond to the label stock installed this will

also cause the printer to print over the gap and onto the

next label. Make sure this is set correctly. 

6.  Sensor Position. Circular, nonstandard label shapes or 

multiple labels across will require precise adjustment of 

the label sensor. If you are using circular or other non 

rectangular die-cut labels see Section 2F for instructions.

Two printer driver settings can affect this issue. 

Left Margin Offset.

 This adjustment is found in the printer 

preferences area of the printer driver. If you see white space on

the right (printers left) side of the label and overlap on the

opposite side, decrease the number (negative numbers are

allowed). If you see white space on the left (printers right) 

side of the label and overlap on the opposite side increase the

number. 

510984.qxd  11/21/2006  9:09 AM  Page 45