Ricoh SP 5100N ユーザーズマニュアル
10.3
<Installing accessories>
Removing a DIMM
To expand the printer memory to 512 MB, you need to remove the
preinstalled 128 MB DIMM and install two 256 MB DIMMs into the DIMM
slots.
preinstalled 128 MB DIMM and install two 256 MB DIMMs into the DIMM
slots.
Push the latches at both ends of the DIMM slot away to remove the
DIMM and pull out the DIMM.
DIMM and pull out the DIMM.
Using the hard disk
Installing the hard disk allows the data from your computer to be sent to
the print queue of the printer hard disk. This decreases the workload of
the computer. You can also use various print features, such as storing a
job in the hard disk, proofing a job, and printing private documents.
the print queue of the printer hard disk. This decreases the workload of
the computer. You can also use various print features, such as storing a
job in the hard disk, proofing a job, and printing private documents.
Installing the hard disk
For order information, see page 7.1.
Review the precautions on page 10.1.
1
Turn the printer power off and unplug the power cord and printer
cable from the printer.
cable from the printer.
1
2
1
latch
2
DIMM
2
Remove the duplex-slot cover or the duplex unit from the back of
the printer.
the printer.
3
Grasp the control board cover and remove it.
4
Align the connector on the hard disk with the connector on the
control board. Push the hard disk in until it is latched into place.
control board. Push the hard disk in until it is latched into place.
1
duplex-slot cover
1