Ricoh LD320d ユーザーズマニュアル
When You Cannot Make Copies As Wanted
17
2
❖ Duplex (Type 2 only)
When Memory Is Full
This section describes likely causes of and possible solutions for problems relat-
ed to full memory.
ed to full memory.
Problem
Cause
Solution
Cannot print in duplex
mode.
mode.
You may have loaded paper on
the bypass tray.
the bypass tray.
Remove paper loaded on the by-
pass tray. Load paper in Tray 1 - 4.
pass tray. Load paper in Tray 1 - 4.
Cannot print in duplex
mode.
mode.
You have loaded paper exceeding
90 g/m
90 g/m
2
.
Change the paper.
Cannot print in duplex
mode.
mode.
You have selected a tray that is set
to [Off] for duplex printing in
[Tray Paper Settings]
to [Off] for duplex printing in
[Tray Paper Settings]
under [System
Settings]
.
Select a paper tray in [Tray Paper
Settings]
Settings]
under [System Settings],
and then press [OK]. Then, select
[No Display (Plain Paper)]
[No Display (Plain Paper)]
or [Recy-
cled Paper]
for Paper Type, press
[Duplex]
, and then select [On]. See
“Tray Paper Settings”, General
Settings Guide.
Settings Guide.
Copies are not in du-
plex order.
plex order.
You placed the originals in the in-
correct order.
correct order.
When placing a stack of originals
in the ADF or ARDF, the last page
should be on the bottom.
in the ADF or ARDF, the last page
should be on the bottom.
If you place an original on the ex-
posure glass, start with the first
page to be copied.
posure glass, start with the first
page to be copied.
When using Duplex,
copy is made Top to
Bottom even though
[Top to Top]
copy is made Top to
Bottom even though
[Top to Top]
is selected.
You placed the originals in the
wrong orientation.
wrong orientation.
Place the original in the correct
orientation. See “Original Orien-
tation”, Copy Reference.
orientation. See “Original Orien-
tation”, Copy Reference.
Parts of the original im-
age are not copied.
age are not copied.
The margin is too wide.
Set a narrower margin with User
Tools. See “User Tools Menu (Copi-
er Features)”, Copy Reference.
Tools. See “User Tools Menu (Copi-
er Features)”, Copy Reference.
Message
Cause
Solution
Press [Resume]
to scan and copy
remaining orig-
inals.
The machine checks if the remain-
ing originals should be copied, af-
ter the scanned original has been
printed.
ing originals should be copied, af-
ter the scanned original has been
printed.
To continue copying, remove all
copies, and then press [Resume].
To stop copying, press [Stop].
copies, and then press [Resume].
To stop copying, press [Stop].