Lantronix LPS1-T ユーザーズマニュアル
2-1
2: Installation
This chapter describes the various MPS models and shows how to install them into a
basic network situation.
basic network situation.
2.1 MPS/LPS Product Description
The front panel of the MPS100 has a Test button, 3 LEDs, a power connector, and an
RJ45 connector for 100BASE-T. The rear panel has a Centronics connector. The front
RJ45 connector for 100BASE-T. The rear panel has a Centronics connector. The front
panel of the LPS has a Test button, 2 LED’s, a power connector, and a 10BASE-T
network connector for the LPS1-T or a 10BASE-2 BNC connector for the LPS1-2. The
rear panel also has a Centronics connector.
network connector for the LPS1-T or a 10BASE-2 BNC connector for the LPS1-2. The
rear panel also has a Centronics connector.
The LINK LED is solid green when there is a valid Ethernet network connection. The
ACT (Activity) LED flashes green or red when the MPS is in use. The 100 (100 MBit)
LED (MPS100 only) is solid green when a 100BASE-T network is connected.
ACT (Activity) LED flashes green or red when the MPS is in use. The 100 (100 MBit)
LED (MPS100 only) is solid green when a 100BASE-T network is connected.
The Test button serves two functions. When pressed briefly, it prints a test page. When
pressed for five seconds while plugging in the power cable, it returns the MPS to its
factory default configuration.
pressed for five seconds while plugging in the power cable, it returns the MPS to its
factory default configuration.
TEST
LINK
5VDC
AC
T
100
Centronics Connector
“front”
“back”