KYOCERA 2020D ユーザーズマニュアル

7-4

Using the Operation Panel

The message display on the operation panel shows:

Status information, the ten messages listed below which are 
displayed during normal operation.

Error codes, when the printer requires the operator’s attention; as 
explained in the Operation Guide.

Refer to the Troubleshooting section in the Operation Guide.

Self test

The printer is performing self-diagnostics after power-up.

Please wait

The printer is warming up and is not ready. 

When the printer is switched on for the first time, this message will take several minutes.

Please wait
(Adding toner)

Toner is currently being replenished. This message may be displayed during continuous 
printing of a large volume of pages which require a large amount of toner such as with 
photographs, etc.

Ready

The printer is ready to print.

Processing

The printer is receiving data to print. This is also shown when the printer is reading a CF 
card, USB memory, hard disk, or RAM disk.

Sleeping

The printer is in Auto Sleep. The printer wakes from Auto Sleep whenever a print job is 
received. The printer then warms up and goes on-line.

For details on Auto Sleep, refer to Sleep Timer (Sleep timer timeout time) on page 7-61.

Canceling data

Jobs inside the printer are being canceled. To cancel a job, refer to Canceling a Printing 
Job on page 7-6.