KYOCERA 2020D ユーザーズマニュアル

Using the Operation Panel

7-65

To set up the Security functions, you must enter an administrator ID and 
administrator password. For information on how to set the administrator 
password, refer to Admin (Administrator settings) on page 7-78.

1

When you entered the ID in the previous step (ID (Administrator ID 
input)), the message display shows 

Password (Administrator 

password input) and a blinking cursor (

_).

2

Press 

U or V to increase or decrease, respectively, the value at the 

blinking cursor. Enter the specified password. Use 

Y and Z to move 

the cursor right and left. Enter a password consisting of between 0 
(no settings) and 16 numbers.

3

Press 

[OK]. The Security screen appears.

You can use this to lock and thereby protect the interface. The options 
available in Interface Block are as follows:

USB Host (USB memory slot setting)

USB Device (USB interface setting)

Parallel I/F (Parallel interface)

Option I/F (Network interface card setting)

1

After entering the administrator ID and password, press 

U or V 

repeatedly until 

>I/F Block > appears.

This locks and protects the USB memory slot (USB host). The default 
setting is 

Unblock.

1

Press 

Z while >I/F Block > is displayed. >>USB Host appears.

2

Press 

[OK]. A blinking question mark (?) appears.

3

Select 

Block or Unblock using U or V.

4

Press 

[OK].

5

Press 

[MENU]. The display returns to Ready.

If you enter an incorrect administrator ID or password, 

the  message 

Wrong ID or Wrong Password appears and 

the input screen then reappears. Re-enter the password 
correctly.

Password
_

>I/F Block     >

>>USB Host
? Unblock