Sharp DX-C200P ユーザーズマニュアル
7.
Press the [ ] or [ ] key to display [DHCP], and then press the [OK] key.
IPv6 Config.:
DHCP
DHCP
8.
Press the [ ] or [ ] key to select [On], and then press the [OK] key.
DHCP:
On
On
The address will be detected by the printer
9.
Press the [Menu] key.
10.
If you are requested to restart the printer, turn off the printer, and then turn it back on.
11.
Print a configuration page to confirm the settings made.
Setting the Ethernet Speed
You can set the speed that the printer will use for Ethernet communication. For normal usage, the default
setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected
interfaces to automatically determine the optimum speed that they will communicate at.
setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected
interfaces to automatically determine the optimum speed that they will communicate at.
Router/HUB
Printer
[10Mbps
Half D.]
[10Mbps Full
D.]
[100Mbps
Half D.]
[100Mbps
Full D.]
[Auto Select]
10Mbps Half
Duplex
Duplex
10Mbps Full
Duplex
Duplex
100Mbps Half
Duplex
Duplex
100Mbps Full
Duplex
Duplex
auto-
negotiation
(auto selection)
negotiation
(auto selection)
Ethernet Configuration
49