Sharp ML-4550 ユーザーズマニュアル
2.8
<System setup>
Printing a demo page
After setting up your printer, print a demo page to make sure that the
printer is operating correctly.
printer is operating correctly.
Press and hold Demo for about 2 seconds.
Or,
1
Press Menu and then OK when 1. Information appears.
2
Press the Scroll buttons until Demo Page appears and press OK.
3
Press OK when Yes appears.
A demo page prints out.
Changing the display language
To change the language that is displayed on the control panel, follow
these steps:
these steps:
1
Press Menu until 5. System Setup appears on the bottom line of
the display and press OK.
the display and press OK.
2
Press the Scroll buttons until Language appears and press OK.
3
Press the Scroll buttons to select the language you want and press
OK.
OK.
4
Press Stop to return to Standby mode.
Using toner save mode
Toner save mode allows the printer to use less toner on each page.
Activating this mode extends the life of your toner cartridge and reduces
your cost per page beyond what one would experience in the normal
mode, but it reduces print quality. This setting is not available with the
1200dpi-Best setting.
Activating this mode extends the life of your toner cartridge and reduces
your cost per page beyond what one would experience in the normal
mode, but it reduces print quality. This setting is not available with the
1200dpi-Best setting.
There are two ways to enable this mode:
Using the control panel button
Press Toner Save on the control panel. The printer must be in Standby
mode; the Status LED lights green and Ready is shown on the display.
• If the button backlight is on, the mode is enabled and the printer uses
mode; the Status LED lights green and Ready is shown on the display.
• If the button backlight is on, the mode is enabled and the printer uses
less toner to print a page.
• If the button backlight is off, the mode is disabled and the printer
prints in normal mode.
From the software application
You can set toner save mode from the printer properties window on your
printer driver. See the Software Section.
printer driver. See the Software Section.
Changing the font setting
Your machine has preset the font for your region or country. If you want
to change the font which you prefer or set the font under special
condition such as the DOS environment, you can change the font setting
as follows:
to change the font which you prefer or set the font under special
condition such as the DOS environment, you can change the font setting
as follows:
1
Press Menu on the control panel until you see 6. Emulation
feature.
feature.
2
Press OK to access the font setting.
3
Press the left/right arrow until Setup displays.
4
Press the left/right arrow until PCL displays.
5
Press the left/right arrow until Symbol displays.
6
Press the left/right arrow until your preferred font displays.
7
Press OK.
8
Press Stop to return to machine ready mode.
Note
Following information shows the proper font list for
corresponding languages.
•Russian: CP866, Cyrillic
corresponding languages.
•Russian: CP866, Cyrillic
•Hebrew: 15Q, 8H, 0H (Israel only)
•Greek: GREEK, PC737
•Arabic & Farsi: ARABIC8, WINARABIC, PC864, FARSI,
•Greek: GREEK, PC737
•Arabic & Farsi: ARABIC8, WINARABIC, PC864, FARSI,
ISOARABIC.