Sharp ML-4550 ユーザーズマニュアル
4.3
<Network setup>
Configuring IPX frame types
To use IPX/SPX protocol networks (for example, Novell NetWare), the
format of the network communication frames must be specified for the
printer. In most cases, you can keep the Auto setting. However, you can
manually set the frame type format, if required. Take the following step
to change the frame type format:
format of the network communication frames must be specified for the
printer. In most cases, you can keep the Auto setting. However, you can
manually set the frame type format, if required. Take the following step
to change the frame type format:
1
Press Menu until Network appears on the bottom line of the
display and press OK.
display and press OK.
2
Press the Scroll buttons until NetWare appears and press OK.
3
Press the Scroll buttons until the desired frame type appears.
• Auto: Automatically senses and limits the frame type to the first
• Auto: Automatically senses and limits the frame type to the first
one detected.
• 802.2: Limits the frame type to IPX over IEEE 802.2 with IEEE
802.3 frames. All others will be discarded.
• 802.3: Limits the frame type to IPX over IEEE 802.3 frames. All
others will be discarded.
• Ethernet II: Limits the frame type to IPX over Ethernet Frames. All
others will be discarded.
• SNAP: Limits the frame type to IPX over SNAP with IEEE 802.3
frames. All others will be discarded.
• Off: Disables the IPX/SPX protocol.
4
Press OK to save the selection.
5
Press Stop to return to Standby mode.
Setting Ethernet speed
You can select the communication speed for Ethernet connections.
1
Press Menu until Network appears on the bottom line of the
display and press OK.
display and press OK.
2
Press the Scroll buttons until Ethernet Speed appears and press
OK.
OK.
3
Press the Scroll buttons until the speed you want appears and
press OK.
press OK.
4
Press Stop to return to Standby mode.
Restoring the network configuration
You can return the network configuration to its default settings.
1
Press Menu until Network appears on the bottom line of the
display and press OK.
display and press OK.
2
Press the Scroll buttons until Clear Setting appears and press
OK.
OK.
3
Press OK when Yes appears to restore the network configuration.
4
Power the printer off and back on.
Printing a network configuration page
The network configuration page shows how the network interface card
on your printer is configured.
on your printer is configured.
1
Press Menu until Network appears on the bottom line of the
display and press OK.
display and press OK.
2
Press the Scroll buttons until Network Info appears and press OK.
3
Press OK when Yes appears.
The network configuration page prints out.