Sharp MX-7500N ユーザーズマニュアル

This function allows you to set for finish on copied or printed pages.
You can select the manual finishing mode if the inserter is installed.
When the finisher (100-sheet stapling), saddle finisher (100-sheet stapling), punch module, or folding unit is installed, finishing operations, such as stapling, punching or folding, can be performed.

 

„

Changing modes from the Home 

Screen

Adjust the inserter tray guide to the pa-

per size, and load paper.

(Special media such as transparency 

film and tab paper cannot be used.)

The output tray is automatically selected based on the output 

function you set. If Z-Fold, Half Fold, or Punch is selected, however, 

you can select the middle or offset tray for the output tray.

If you have changed the output tray, the output function may be 

deselected depending on the original output settings.

Selects the middle tray as the output tray

Selects the offset tray as the output tray

Orientation of placed original
For stapling or punching on the desired position, 
place the paper as shown in the following:
•  For staple function, place the paper face up and 

align text with the direction of the touch panel 
display. (For the saddle stitch function, place the 
paper so that middle surface faces up.

•  When using punch or folding function, place the pa-

per face up, and align text horizontally and upward 
with the scan (right) direction.

You can check the type and size of paper loaded.

As needed, the paper type and size can be specified for each of the

upper and lower trays.

If you wish to change the paper sizes or types, select [System 

Settings] > [Paper Tray Settings] > [Inserter].

Check the paper type and size

Selects the upper tray as paper tray

Selects the lower tray as paper tray