Funkwerk R4300 IP Additional X.21 interface License 24566 ユーザーズマニュアル

TCP/IP routing

Routing information updating and distribution, static or dynamic (RIP v1/v2/triggered, RFC
2091), selectable for each interface, ProxyARP, BOOTP/DHCP forwarding

Extended IP routing

Dependent on source/destination port, source IP address, TOS ..., i.e. policy-based routing

X.25 Enhanced

Optional: X.25 over ISDN, XOT, X.25 to TCP Gateway, X.25 PAD, TP0 Bridge

OSPF

Static/dynamic updating and distribution of routing information

Bridging

Spanning Tree & Transparent Mode

QoS

Quality of Service with DiffServ and shaping: breakdown of IP data traffic into classes with
different priorities, optimized queue handling and shaping as per these priorities

TCP Download Rate Control

Optimal for VoIP transmission

BRRP

Bintec Router Redundancy Protocol, back up a service offered by a single physical router to a
LAN (Virtual Router)

IP load balancing

Bandwidth management

BoD

Bandwidth on Demand: Scalable bandwidth to suit data traffic load

AUX backup

Backup via GSM, GPRS or analogue modem

PPP

Authentication mechanisms (PAP, CHAP, MS-CHAP, MS-CHAP v2), standard PPP, channel
bundling over Multilink PPP (ML-PPP), transparent mode, dynamic IP address assignment
(server and client mode)

PPPoE

Point-to-Point Protocol over Ethernet (Client and Server) for high-speed Internet access over
xDSL (RFC 2516)

LAN user - ISDN WAN partner

Unlimited number

Dyn. IP addresses

Simple Internet access without fixed IP addresses

ISDN accounting

Call detail recording, number, charging information, ...

IP accounting

Source, destination, port, interface, packets/bytes counter

Event Scheduler

Budgets based on data volume or based on time

Short hold

Static and dynamic short hold saves connection costs through automatic call clearing

Keep Alive Monitoring

Saves costs by only allowing a connection to be set up if configurable IP addresses can be
reached

STAC

Compression for PPP connections, free-of-charge licence necessary

Cost of ownership

Minimum, e.g. due to free software updates, full remote administration

RISC architecture

Motorola 8241 RISC processor with 32 MB RAM

Flash ROM

8 MB on board

4+1-port switch

4+1-port autosensing 10/100 Mbps Ethernet switch

ISDN

2 x BRI (4 B channels)

Serial interface

1 x serial interface (X.21 / V.35) , opt. additional 1 x serial interface via license

Console

Serial console port: RS 232 C, RJ45, 1,200 bps - 115 kbps

Power supply

External AC/DC converter 15 V DC, 1,24 A (approx. 1,5 W per internal ISDN-Bus)

On/off switch

Available

Status LEDs

Power, Status, 10 x Ethernet, 8 x Function (ISDN, ADSL, WLAN, ...)

Housing

Metal housing

19-inch

Optional: suitable for mounting in 19-inch cabinet via a 19-inch rack-mount kit

Fanless design

Long lifetime

Dimensions

Approx. 295 x 45 x 160 mm (W x H x D)

  Funkwerk Enterprise Communications GmbH - Suedwestpark 94 - 90449 Nuremberg - Germany
  Phone: +49 - 180 300 9191 0
  Fax: +49 - 180 300 9193 0
  E-Mail: info@funkwerk-ec.com - www.funkwerk-ec.com  

bintec R4300
13.06.2007
Subject to technical
alterations