Sharp AR-M230 ユーザーズマニュアル

Printing begins. The print job is delivered to one of the 
following trays (depending on which output devices are 
installed):

●

Job separator tray kit is installed: Upper tray

●

Finisher is installed: Center tray

If "Paper Selection" is set to "Auto Select" in the "Paper" tab of 
the printer driver setup screen and the correct size of paper for 
a print job is not loaded in the machine, the printing procedure 
will vary depending on the "FORCED OUTPUT OF PRINT" 
setting in the key operator programs (see the key operator's 
guide).

If the bypass tray can be used, a message prompting you to 
print from the bypass tray will appear in the touch panel. 
Press the [PRINT] key on the operation panel, touch the 
[BYPASS TRAY] key, load paper in the bypass tray, and then 
touch the [BYPASS] key. Printing will begin automatically.

Printing will take place using a size of paper that is close to the 
size of the print image.

●

The output tray can be selected in the key operator 
programs (see "OUTPUT TRAYS" in the key 
operator's guide).

●

The output tray can also be selected in the print 
settings at the time of printing. To change the tray 
selection, select the desired tray in "Output" in the 
"Paper" tab of the printer driver setup screen.

●

Printing can be canceled in the job status screen.

●

If the paper type setting in the printer driver is different 
from the bypass tray's paper type setting in the 
machine, printing may stop. To resume printing, press 
the [PRINT] key on the operation panel, touch the 
[BYPASS TRAY] key in the touch panel, and specify 
the same paper type as in the printer driver.

If the paper is loaded in a different orientation than the 
print image, the image is automatically rotated to match 
the paper. This setting can be changed in the key 
operator programs (see "ROTATED PRINT" in the key 
operator's guide).