Netgear FWG114P v2 ユーザーズマニュアル

11-2

Troubleshooting

When the router is turned on, the LEDs turns on for about 10 seconds and then turns off. If all the 
LEDs stay on, there is a fault within the router.

If all LEDs are still on one minute after power up:

•

Cycle the power to see if the router recovers.

•

Clear the router’s configuration to the factory defaults. This will set the router’s IP address to 
192.168.0.1. This procedure is explained in 

If the error persists, you might have a hardware problem and should contact technical support.

If either the LAN LEDs or the Internet LED do not light when the Ethernet connection is made, 
check the following:

•

Make sure that the Ethernet cable connections are secure at the router and at the hub or 
workstation.

•

Make sure that power is turned on to the connected hub or workstation.

•

Be sure you are using the correct cable:

When connecting the router’s Internet port to a broadband modem, use the cable that was 
supplied with the broadband modem. This cable could be a standard straight-through Ethernet 
cable or an Ethernet crossover cable.