Netgear FWG114P v2 ユーザーズマニュアル

Connecting the FWG114P v2 to the Internet

3-19

Use these steps to manually configure the primary Internet connection in the Basic Settings menu.

1.

Select your Internet connection type (broadband with or without login, or serial).

Note:  If you are a Telstra BigPond broadband customer, or if you are in an area, such as 
Austria that uses broadband PPTP, login is required. If so, select BigPond or PPTP from the 
Internet Service Type drop down box.

2.

Enter your Account Name (may also be called Host Name) and Domain Name. These 
parameters may be necessary to access your ISP’s services, such as mail or news servers.

3.

If needed, enter the PPPoE login user name and password provided by your ISP. These fields 
are case sensitive. To change the login timeout, enter a new value in minutes.

Note: You will no longer need to run the ISP’s login program on your computer in order to 
access the Internet. When you start an Internet application, your firewall automatically logs 
you in.

4.

You should only disable NAT if you are sure you do not require it. NAT automatically assigns 
private IP addresses (for example, 192.168.0.x) to LAN connected devices. When NAT is 
disabled, only standard routing is performed by this router. 

Note: Disabling NAT will reboot the router and reset all the FWG114P v2 configuration 
settings to the factory default. Disable NAT only if you plan to install the FWG114P v2 in a 
setting where you will be manually administering the IP address space on the LAN side of the 
router.

5.

Internet IP Address: If your ISP assigned you a permanent, fixed IP address for your computer, 
select “Use Static IP Address.” Enter the IP address your ISP assigned. Also enter the IP 
Subnet Mask and the Gateway IP address. The Gateway is the ISP’s router to which your 
firewall will connect.

6.

Domain Name Server (DNS) Address: If your ISP does not automatically transmit DNS 
addresses to the firewall during login, select “Use These DNS Servers” and enter the IP 
address of your ISP’s Primary DNS Server. If a Secondary DNS Server address is available, 
enter it.

Note: A DNS server is a host on the Internet that translates Internet names (such as 
www.netgear.com) to numeric IP addresses. Typically your ISP transfers the IP address of one 
or two DNS servers to your firewall during login. If the ISP does not transfer an address, you 
must obtain it from the ISP and enter it manually here. If you enter an address here, you should 
reboot your PCs after configuring the firewall.