HP (Hewlett-Packard) 70 ユーザーズマニュアル
Connect the Timing Analyzer
Note
If you have a termination adapter, HP part number 01650-63203, connect
the adapter between Pod 3 of the logic analyzer and J2 of the training
board, then go to the next page to put the analyzer into state and timing
modes.
the adapter between Pod 3 of the logic analyzer and J2 of the training
board, then go to the next page to put the analyzer into state and timing
modes.
1
Connect the Pod 3 connector to the probe assembly.
For the HP 1660s, Pod 3 is the top cable in the second connector from the
left, as you are facing the back of the logic analyzer. For the HP 1670s, Pod 3
is the top cable in the second connector from the right, as you are facing the
back of the logic analyzer.
left, as you are facing the back of the logic analyzer. For the HP 1670s, Pod 3
is the top cable in the second connector from the right, as you are facing the
back of the logic analyzer.
Note
Leave Pod 1 connected to J1 of the training board. Pod 1 provides the
+5 V power for the training board.
+5 V power for the training board.
2
Connect the probe leads 0 through 7 to the pins D0 through D7 of J2.
3
Connect the probe ground lead to any pin of J3.
Connecting the Pod 3 Cable to the Probe Assembly
Probe Assembly
Pod 3 Connector
Mixed Mode - Correlation of State and Timing Data
Connect the Timing Analyzer
Connect the Timing Analyzer
5-4