GCC Printers 21 Series ユーザーズマニュアル
6-10
7. Input/Output (continued)
• NetWare*: Sets the built-in Novell NetWare support to Disabled or Enabled.
• RS-232 Baud Rate: Sets the baud rate for the RS-232 Serial interface.
Default is 9600 bps. This setting should match the COM port setting on the
PC.
PC.
• RS-232 Data Bits: Sets the data bits for the RS-232 Serial interface. Default
is 8 bits. This setting should match the COM port setting on the PC.
• RS-232 Stop Bits: Sets the stop bits for the RS-232 Serial interface. Default is
1 bit. This setting should match the COM port setting on the PC.
• RS-232 Parity: Sets the parity for the RS-232 Serial interface. Default is
None. This setting should match the COM port setting on the PC.
• RS-232 Flow Control: Sets the flow control for the RS-232 Serial interface.
Default is Hardware. This setting should match the COM port setting on the
PC.
PC.
Note: Changes made to items marked with an asterisk (*) will not take effect
until the printer is restarted.
until the printer is restarted.
8. Resets
• Restore Defaults: Sets all menu items in all menus back to their factory
defaults. This change requires an immediate restart to take effect.
• Restore Network: Sets all network items back to their factory defaults. This
change will not take effect until the printer is restarted.
• Initialize Disk: Initializes the printer’s internal hard disk. This will remove any
downloaded fonts and/or held jobs from the disk. This change requires an
immediate restart to take effect. This menu item only appears if the printer is
equipped with an internal hard drive.
immediate restart to take effect. This menu item only appears if the printer is
equipped with an internal hard drive.