Intellinet Network Solutions 509077 ユーザーズマニュアル

Double-click the System icon to display the System configuration screen, where 

you can see all available printing protocols and upgrade the firmware.
Port name: You can name the port the MFP server connects to. The default port 

  name is ‘’p1.’’

Upgrade Firmware: You can use this Upgrade Firmware tool to upload the

  newest firmware for the MFP server. Click     and select the correct firmware in 

  your PC. After selecting the firmware file, click “Upgrade” to finish the firmware

  update process. NOTE: Before you upgrade the firmware, make sure the IP

  address settings of the MFP server are in the same network as your computer.

load default: Click to reset the MFP server to default factory settings.

Wireless Function: Select “Auto,” “Enable” or “Disable” to manually configure the

  wireless function. 

  • “Auto” is the default setting of the MFP server. In this mode, the MFP server

    will automatically decide to enable or disable the wireless function. When the

    MFP server starts up, it will auto-detect if the lAN port is connected to an

    active network by an ethernet cable. If this is the case, the MFP server will run

    in ethernet mode. If the MFP server is not connected to an active network by

    an ethernet cable, the MFP server will run in wireless lAN mode. 

    You can plug the Ethernet cable into the MFP server, then, after configuring 

    the MFP server features and wireless settings, unplug the ethernet cable to

    enable the wireless connection. This makes the configuration much easier

    without creating the wireless connection in advance. NOTE: After setting the

    wireless function, remove the ethernet cable and then remove and re-connect 

    the power cable of the  MFP server to activate the wireless connection.

2

SERVER CONFIGURATION