Zebra Technologies P1013372-001 REV. A ユーザーズマニュアル
Installation and Setup
Loading Cards
P1013372-001 Rev. A
Zebra ZXP Series 8 Card Printer with Laminator
11
Loading Cards
Step 1.
Remove the wrapping from the card deck.
Step 2.
Holding the card deck by the sides (do not touch the print surfaces), hold it
vertically against a flat surface such as a desktop. If the deck is too thick for your
hand to hold it comfortably, use about half a deck at a time.
vertically against a flat surface such as a desktop. If the deck is too thick for your
hand to hold it comfortably, use about half a deck at a time.
Step 3.
Push the stack back and forth to an angle of about 45
°
from vertical, so as to separate
all of the cards.
Step 4.
Restore the card stack to its original squared-off condition.
Step 5.
Open the Input Hopper Door.
Step 6.
Place the cards in the Input Hopper in the orientation as shown (smartcard contacts, if
present, up and toward the body of the printer; mag stripe, if present, down and to the
rear). Ensure that the cards are seated flat on the bottom of the hopper.
present, up and toward the body of the printer; mag stripe, if present, down and to the
rear). Ensure that the cards are seated flat on the bottom of the hopper.
Step 7.
Close the Input Hopper Door.
Caution •
DO NOT
bend cards or touch print surfaces as this can reduce print quality.
The surface of the cards must remain clean and dust free. Always store cards in an
enclosed container. Ideally, use cards as soon as possible.
enclosed container. Ideally, use cards as soon as possible.
Note •
Static charges and edge burrs from the card die-cutting process can render individual
cards stuck together with significant adhesion force. These cards must be physically separated
from each other before inserting into the feeder; if not separated, feeding or printing problems
may occur.
from each other before inserting into the feeder; if not separated, feeding or printing problems
may occur.