Zebra Technologies P1013372-001 REV. A ユーザーズマニュアル
Printer Settings and Adjustments
Card Printer Properties
P1013372-001 Rev. A
Zebra ZXP Series 8 Card Printer with Laminator
67
Ports Tab
Use the Ports tab to specify the computer port to which the printer is connected. This will have
been established at the initial installation of the printer, and will not normally require attention.
been established at the initial installation of the printer, and will not normally require attention.
To access the Ports tab, select Start > Printers and Faxes. Right click on the Zebra ZXP
Series 8 Card Printer listing. Select Properties > Ports.
Series 8 Card Printer listing. Select Properties > Ports.
An exception to this is if you wish to use printer pooling, the ability to distribute print jobs to
multiple printers; see
multiple printers; see
on page 189 for details.
To enable printer pooling, check the “Enable printer pooling” box, then check the additional
ports boxes. Each port should have a single Zebra printer installed on it. All the pooled printers
must be identical models with the same configuration (e.g., all with YMC front, K back); and
each must have its own printer driver installed.
ports boxes. Each port should have a single Zebra printer installed on it. All the pooled printers
must be identical models with the same configuration (e.g., all with YMC front, K back); and
each must have its own printer driver installed.
Now, when you print to the “main printer” (that is, whichever printer you right-clicked in
Printers and Faxes to get to this screen), this printer will get print jobs until it has buffered as
many jobs as it can take. Remaining jobs will then “spill over” to other printers until all
printers in the pool are busy.
Printers and Faxes to get to this screen), this printer will get print jobs until it has buffered as
many jobs as it can take. Remaining jobs will then “spill over” to other printers until all
printers in the pool are busy.