Zebra Technologies ZM400201101L0T ユーザーズマニュアル

Printer Setup
Select a Data Communication Interface

79695L-001 Rev. A

ZM400/ZM600 User Guide

3/27/07

You must supply all data cables or wireless cards for your application.

Data Cables  Ethernet cables do not require shielding, but all other data cables must be fully 
shielded and fitted with metal or metallized connector shells. Unshielded data cables may 
increase radiated emissions above the regulated limits.

To minimize electrical noise pickup in the cable:

• Keep data cables as short as possible.

• Do not bundle the data cables tightly with the power cords.

• Do not tie the data cables to power wire conduits.

Wireless Cards  For supported wireless cards, refer to the ZebraNet Wireless Print Server 
and Wireless Plus Print Server User Guide. A copy of the manual is available at 

 or on the user CD that came with your printer.

 shows how to connect the different types of data cables to your printer and computer. 

The connectors on the back of your computer may be in different locations than on the sample 
computer shown in this section. For another view of the connectors on the printer, see 

.

Ensure that the printer power is off (

) before connecting data communications 

cables. Connecting a data communications cable while the power is on (

) may damage the 

printer.

RS-232 Serial

The baud rate, number of data and stop bits, the parity, and the 
XON/XOFF or DTR control must match those of the host computer. See 

 to view or change these parameters.