Zebra Technologies UMAN-QLP-001 ユーザーズマニュアル
60
QL Plus Series User Guide
Troubleshooting Topics
1. No power
• Check that battery is installed properly.
• Recharge or replace battery as necessary.
• Recharge or replace battery as necessary.
Always dispose of batteries properly. Refer to Appendix E for more
information on proper battery disposal.
2. Media does not feed:
• Be sure print head is closed and latched.
• Check spindle holding media for any binding.
• If unit is equipped with label presence sensor:
• Check spindle holding media for any binding.
• If unit is equipped with label presence sensor:
Ensure most recently printed label is removed.
Also ensure label sensor is not blocked.
3. Poor or faded print or
flashing:
• Clean print head.
• Check battery and recharge or replace as necessary.
• Check battery and recharge or replace as necessary.
Always dispose of batteries properly. Refer to Appendix D
for more information on proper battery disposal.
for more information on proper battery disposal.
• Check quality of media.
4. Partial or missing print:
• Check media alignment
• Clean print head.
• Ensure printhead is properly closed and latched.
• Clean print head.
• Ensure printhead is properly closed and latched.
5. Garbled print:
• Check baud rate.
6. No print:
• Check baud rate.
• Replace battery.
• Check cable to terminal.
• Establish RF Link (Wireless units only) and/or restore LAN
• Replace battery.
• Check cable to terminal.
• Establish RF Link (Wireless units only) and/or restore LAN
associativity (Printers with WLAN radios only).
• Invalid label format or command structure. Place printer in
Communications Diagnostic (Hex Dump) Mode to diagnose
problem.
problem.
7. Reduced battery charge life
• Check battery date code — if battery is one to two years
old, short charge life may be due to normal aging.
• Recondition battery.
• Replace battery.
• Replace battery.