Zebra Technologies Z6Mplus ユーザーズマニュアル
88
Z4Mplus/Z6Mplus User Guide
13163L Rev. 3 5/20/2004
Troubleshooting
LCD Error Conditions and Warnings
LCD Error Conditions and Warnings
The LCD displays error condition messages and warnings if the printer detects a problem. The
messages, along with their causes and solutions, are listed in
messages, along with their causes and solutions, are listed in
.
Table 12 • Error Conditions and Warnings
Error
Potential Problem
Recommended Solution
RIBBON OUT
In thermal transfer mode, the
ribbon is not loaded or loaded
incorrectly.
ribbon is not loaded or loaded
incorrectly.
Load the ribbon correctly. See
In thermal transfer mode, the
ribbon sensor is not sensing
correctly loaded ribbon.
ribbon sensor is not sensing
correctly loaded ribbon.
Perform the media and ribbon sensor
calibration (see
calibration (see
RIBBON IN
In direct thermal mode, when
ribbon is not used:
ribbon is not used:
.
Ensure that the printer driver or software
settings are correctly set.
settings are correctly set.
PAPER OUT
The media is not loaded or
loaded incorrectly.
loaded incorrectly.
Reload the media. See
The media sensor is not
positioned properly.
positioned properly.
Check the position of the reflective sensor.
See
See
.
The printer is set for
non-continuous media, but
continuous media is loaded.
non-continuous media, but
continuous media is loaded.
Either load the correct media or set the
printer for the correct media type via the
front panel.
printer for the correct media type via the
front panel.
Ensure that the printer driver or software
settings are correctly set.
settings are correctly set.
Calibrate the printer (see
The incorrect media sensor is
being used.
being used.
Via the front panel, locate the SENSOR
SELECT menu item (see
SELECT menu item (see
) and manually select the correct
sensing method.