Zebra Technologies 1050020011570 ユーザーズマニュアル

Configuration
Control Panel Parameters

11342L-001 Rev. A

105SL User Guide

6/30/06

The menu options shown in 

 display only if you have a print server installed.

This parameter, which serves the same function as the 

^NP

 ZPL command, 

specifies whether to use the printer’s or the print server’s IP settings at 
bootup.

Default: PRINTER

Selections: PRINTER, PRINTSERVER

1.

Press 

PLUS ()

 or 

MINUS (–)

 to toggle between the options.

This parameter, which serves the same function as the 

^NB

 ZPL command, 

tells the printer whether to search for a wired print server at bootup.

Default: NO

Selections: YES, NO

1.

Press 

PLUS ()

 or 

MINUS (–)

 to toggle between the options.

Allows either the user (permanent) or the server (dynamic) to select the 
IP address. If a dynamic option is chosen, this selection determines the 
method(s) by which the print server (wired or wireless) receives the IP 
address from the server.

Default: ALL

Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, 
DHCP AND BOOTP, PERMANENT

Use of GLEANING ONLY is not recommended when the 

Wireless Print Server is installed.

1.

Press 

PLUS ()

 or 

MINUS (–)

 to scroll through the options.

1 Appears only when the ZebraNet Wireless Print Server is installed.

2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the 

print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to 
address 192.168.254.254.

3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

LOAD LAN FROM?
PRINTER

WIRED PS CHECK?

NO

IP PROTOCOL

ALL