Zebra Technologies RW 420 ユーザーズマニュアル
28
RW Series User Guide
Connecting the Printer
The printer must establish communications with a host ter-
minal which sends the data to be printed. Communications
occur in three basic ways:
occur in three basic ways:
• By a cable between the printer and its host terminal using
either RS232C or USB protocols
• By means of a Bluetooth short-range radio frequency link
• By means of a wireless LAN (Local Area Network) per
• By means of a wireless LAN (Local Area Network) per
802.11b/g specifications
Cable Communications
Caution • The printer should be turned off before connecting or
disconnecting the communications cable.
Serial (RS232C) and USB Combination Port
Notes • All RW series printers can communicate by cable; the specific
cable supplied with your printer will vary with the host terminal.
For wired communications, Zebra recommends using a serial RJ-45
cable for connection with your RW printer’s RS-232C serial port. A USB
to RJ-45 cable is also available for USB cabled file transfers. The RW
series USB port is intended for setup and maintenance of the printer
only.
The 10- pin modular connector on your communications ca-
ble plugs into the combination RS232C/USB communications
port on the side of the printer. The protocol used with this
port is determined by the communications cable you are us-
ing. (Refer to Appendix A for more information on the com-
port on the side of the printer. The protocol used with this
port is determined by the communications cable you are us-
ing. (Refer to Appendix A for more information on the com-
Figure 12: Communications Port
continued
RS232/USB Port
Align Locking Plug
features with these
cutouts.
Rotate clockwise
Rotate clockwise
to lock the cable
in place; coun-
terclockwise to
unlock the cable.
USB Port