Zebra Technologies 105SL ユーザーズマニュアル
22
105SL User Guide
6/4/2004 11342L Rev. 8
Printer Operation
Roll Media Loading
Roll Media Loading
The different print modes affect the way that media is loaded in the printer.
• Tear-Off mode: Labels are produced in strips.
• Peel-Off mode: Labels are dispensed and peeled from the liner as needed.
• Rewind mode: Labels are rewound internally.
• Cutter mode: Labels are printed and individually cut.
• Peel-Off mode: Labels are dispensed and peeled from the liner as needed.
• Rewind mode: Labels are rewound internally.
• Cutter mode: Labels are printed and individually cut.
Tear-Off Mode
Refer to
.
To load media in Tear-Off mode, complete these steps:
1.
Open the printhead.
2.
Slide the media guide and media supply guide as far from the printer frame as possible.
3.
Load media as shown.
4.
Slide in the media guide and media supply guide so they just touch, but do not restrict, the
edge of the roll.
edge of the roll.
5.
Close the printhead.
Figure 15 • Tear-Off Mode Loading
Note •
A calibration must be performed with all loading modes during the following
circumstances if the printer is set to Feed or No Motion at power up or head close:
• When media and ribbon (if used) are first installed in the printer.
• When media or ribbon is changed to a different type.
• When media and ribbon (if used) are first installed in the printer.
• When media or ribbon is changed to a different type.