Zebra Technologies GX430D ユーザーズマニュアル

Printer Options
Label Dispenser Option

980611-001 Rev. C

GX420d™ / GX430d™ User Guide

8/4/10

The factory installed label dispenser option allows you to print a label with backing 
(liner/web) being removed from the label as it prints, ready for application. When printing 
multiple labels, removing the dispensed (peeled) label notifies the printer to print and dispense 
the next label.

To use dispenser-mode correctly, use your printer driver to activate the label (taken) sensor 
along with these typical label settings which include but are not limited to length, non-
continuous (gap), and web (liner). Otherwise, you must send the ZPL or EPL programming 
commands to the printer.

When programming in ZPL, you can use the following command sequences shown below 
and refer to your ZPL Programming Guide for more information on ZPL programming.

^XA ^MMP ^XZ

^XA ^JUS ^XZ

When programming in EPL, send the Options (

) command with the ‘P’ command 

parameter (

) to enable the Label Taken sensor. Other printer option parameters may also be 

included with the Options command string. Refer to your EPL Programmer’s Guide for more 
information on programming with EPL and the Options (

) command behaviors.

Load your labels into the printer. Close the printer and press the Feed button until a 
minimum of 4 inches or 100 millimeters of exposed labels exit the printer. Remove the 
exposed labels from the liner.