Zebra Technologies LI 72 ユーザーズマニュアル

RW 420 User Guide

Getting Ready to Print
Battery

Battery Safety

The Battery Packs used on Zebra Mobile Printers contain a

great deal of energy and can cause personal injury or start a
ﬁre if used improperly or carelessly. Please observe the fol-
lowing safety practices:

Avoid accidental short circuiting of any battery. Allowing

battery terminals to contact conductive material will create

a short circuit which could cause burns and other injuries or

could start a ﬁre.

Batteries can explode or catch ﬁre if improperly charged

or exposed to high temperatures or ﬁre.
Do not disassemble, crush or expose batteries to water.
CAUTION: Use of any charger not approved speciﬁcally by

Zebra for use with its batteries could cause damage to the

battery pack or the printer and will void the warranty.

Installing the Battery

NOTE: Batteries are shipped uncharged. Remove protective shrink-

wrap and labels from new battery packs prior to use.

1. Rotate the Belt Clip to allow access to the Battery com-

partment.

2. Insert the battery into the printer as shown in Figure 2,
3. Rock the Battery into the printer as shown until it locks in

place.

When the battery is ﬁrst installed, the Control Panel indica-

tors may brieﬂy turn on and then go off, indicating the battery
is not fully charged (see “Charging the Battery” below and
“Operator Controls.”)

Charging the Battery

Model LI 72 Single Battery Charger

Refer to Figure 3. Your battery charger may look slightly dif-

ferent from the one illustrated.

1. Plug the Charger into the appropriate A.C. wall receptacle.

Then insert the charge cable into the battery charger jack.

2. The charger LED will indicate the status of the charger as

follows:

• A steady light indicates the battery is undergoing a fast

charge.

• A slow blinking light indicates the charger is in trickle