DELL X8300-6059 ユーザーズマニュアル

System Setup Utility

This feature allows you to change the boot sequence for devices.

• USB Floppy — The computer attempts to boot from the USB floppy disk 

drive. If no operating system is on the floppy disk, the computer generates 

an error message.

•

Hard Drive — The computer attempts to boot from the primary hard 

drive. If no operating system is on the drive, the computer generates an 

error message.

•

CD/DVD/CD-RW Drive — The computer attempts to boot from the 

CD/DVD/CD-RW drive. If no CD/DVD/CD-RW is in the drive, or if the 

CD/DVD/CD-RW has no operating system, the computer generates an 

error message.

•

USB Storage Device — Insert the memory device into a USB connector 

and restart the computer. When F12 Boot Options appears in the 

lower-right corner of the screen, press <F12>. The BIOS detects the 

device and adds the USB flash option to the boot menu.

To boot to a USB device, the device must be bootable. To ensure that your 

device is bootable, check the device documentation.

• Network — The computer attempts to boot from the network. If no 

operating system is found on the network, the computer generates an error 

message.

To boot from the network, ensure that onboard LAN boot ROM option is 

enabled in the system setup (see "System Setup Utility" on page 103).

You can use this feature to change the current boot sequence, for example, to 

boot from the CD/DVD/CD-RW drive to run the Dell Diagnostics from the 

Drivers and Utilities disc. On completion of diagnostic tests, the previous 

boot sequence is restored.

Exit options

Provides options to Save Changes and 

Reset, Discard Changes and Reset, and 

book.book  Page 109  Wednesday, April 25, 2012  12:34 PM