DELL U7021 ユーザーズマニュアル

ページ / 154
94
Removing and Installing Parts
www
.dell.com | support.dell.com
19 If the drive you just installed is the primary drive, install your operating system on the hard 
drive.
Adding a Second Hard Drive
 
CAUTION: 
Before you begin any of the procedures in this section, follow the safety instructions 
located in the Product Information Guide.
 
CAUTION: 
To guard against electrical shock, always unplug your computer from the electrical outlet 
before opening the cover.
 
NOTICE: 
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a 
surface, such as a foam pad, that will sufficiently cushion it.
1 Check the documentation for the drive to verify that it is configured for your computer.
2 Follow the procedures in "Before You Begin" on page 67.
3 Remove the two plastic rails from the inside of the hard-drive bay by gently pulling the rails 
up and out of the bay.
4 Attach the rails to the hard drive using the two screws attached to the rails.
Ensure that the rail tabs are positioned at the back of the hard drive.
 
NOTICE: 
Do not install any drive into the lower hard-drive bay until you have removed the green drive 
rails from the inside of the hard-drive bay.
5 Remove the first hard drive from the upper bay and install it in the lower bay: 
a
Disconnect the power and the hard-drive cables from the back of the first hard drive.
b
Press in the two rail tabs and pull the first hard drive out of the upper bay.
c
Gently slide the first hard drive into the lower bay until you hear a click.
d
Reconnect the power and hard-drive cables to the back of the first hard drive.
6 Gently slide the new hard drive into the upper bay until you hear a click.