DELL 8132 ユーザーズマニュアル

IPv6 Routing Commands

Use the ipv6 nd managed-config-flag command in Interface Configuration 

mode to set the “managed address configuration” flag in router 

advertisements. When the value is true,
end nodes use DHCPv6. When the value is false, end nodes automatically 

configure addresses.

False is the default configuration.

Interface Configuration (VLAN, Tunnel, Loopback) mode

This command has no user guidelines.

In the following example, the end node uses DHCPv6.

console(config)#interface vlan 15

console(config-if-vlan15)#ipv6 nd managed-config-flag

Use the ipv6 nd ns-interval command in Interface Configuration mode to set 

the interval between router advertisements for advertised neighbor 

solicitations. An advertised value of 0 means the interval is unspecified.

ipv6 nd ns-interval 

milliseconds

2CSPC4.X8100-SWUM102.book  Page 1101  Friday, March 15, 2013  8:56 AM