DELL 8132 ユーザーズマニュアル
IPv6 Routing Commands
1135
Number of Prefixes:
show ipv6 traffic
Use the show ipv6 traffic command in User EXEC mode to show traffic and
statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [vlan
vlan-id | tunnel tunnel-id | loopback loopback-id]
•
vlan-id — Valid VLAN ID, shows information about traffic on a specific
interface or, without the optional parameter, shows information about
traffic on all interfaces.
• tunnel — Tunnel identifier. (Range: 0-7)
• loopback — Loopback identifier. (Range: 0-7)
• loopback — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following examples show traffic and statistics for IPv6 and ICMPv6, first
for all interfaces and an individual VLAN.
console> show ipv6 traffic
IPv6 STATISTICS
Total Datagrams
Received........................................... 0
Received Datagrams Locally
Delivered.......................................... 0
Received Datagrams Discarded Due To Header Errors.. 0
2CSPC4.X8100-SWUM102.book Page 1135 Friday, March 15, 2013 8:56 AM