DELL 8132 ユーザーズマニュアル
1158
Multicast Commands
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pim rp-candidate vlan 10 239.1.0.0 255.255.0.0 interval 30
ip pim sparse
Use the ip pim sparse command in Global Configuration mode to
administratively configure PIM sparse mode for IP multicast routing. Use the
no form of this command to disable PIM.
Syntax
ip pim sparse
no ip pim sparse
no ip pim sparse
Default Configuration
PIM not enabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router. It is
recommended that IGMP be enabled if PIM is enabled.
IP multicast must be enabled for PIM to operate.
It is recommended that IGMP snooping be disabled if IP multicast is enabled
IP multicast must be enabled for PIM to operate.
It is recommended that IGMP snooping be disabled if IP multicast is enabled
unless specifically required.
Example
console(config)#ip pim sparse
2CSPC4.X8100-SWUM102.book Page 1158 Friday, March 15, 2013 8:56 AM