DELL 8132 ユーザーズマニュアル

OSPF Commands

Use the area stub no-summary command in Router OSPF Configuration 

mode to prevent Summary LSAs from being advertised into the NSSA. Use 

the no form of the command to return the Summary LSA mode to the 

default value.

area 

area-id stub no-summary

no area 

area-id stub no-summary

•

area-id — Identifies the OSPF area to configure. (Range: IP address or 

decimal from 0–4294967295)

Disabled is the default configuration.

Router OSPF Configuration mode.

This command has no user guidelines.

The following example prevents the Summary LSA from being advertised 

into the area 3 NSSA.

console(config-router)#area 3 stub no-summary

Use the area virtual-link command in Router OSPF Configuration mode to 

create the OSPF virtual interface for the specified area-id and neighbor 

router. To remove the link, use the no form of the command. Use the optional 

parameters to configure authentication, dead-interval, hello-interval, 

retransmit-interval and transmit-delay. If the area has not been previously 

created, it is created by this command. If the area already exists, the virtual-

link information is added or modified.

2CSPC4.X8100-SWUM102.book  Page 1211  Friday, March 15, 2013  8:56 AM