DELL 8132 ユーザーズマニュアル

OSPF Commands

Router OSPF Configuration mode.

This command has no user guidelines.

The following example configures the dead interval for the area 10 OSPF 

virtual interface on the virtual interface and neighbor router. 

console(config-router)#area 10 virtual-link 

192.168.2.2 dead-interval 655555

Use the area virtual-link hello-interval command in Router OSPF 

Configuration mode to configure the hello interval for the OSPF virtual 

interface on the virtual interface identified by the area ID and neighbor ID. 

Use the no form of the command to return the hello interval to the default 

value.

area 

area-id virtual-link neighbor-id hello-interval seconds

no area 

area-id virtual-link neighbor-id hello-interval

•

area-id — Identifies the OSPF area to configure. (Range: IP address or 

decimal from 0–4294967295)

•

neighbor-id — Identifies the Router ID of the neighbor.

•

seconds — Number of seconds to wait before sending hello packets to the 

OSPF virtual interface. (Range: 1–65535)

10 seconds is the default configuration.

Router OSPF Configuration mode.

2CSPC4.X8100-SWUM102.book  Page 1216  Friday, March 15, 2013  8:56 AM