DELL 8132 ユーザーズマニュアル
OSPF Commands
1233
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan15)#ip ospf cost 5
ip ospf database-filter all out
Use the ip ospf database-filter all out command in Interface Configuration
mode to prevent flooding of OSPF LSAs on an interface.
Use the no form of the command to enable flooding of LSAs on an interface.
Use the no form of the command to enable flooding of LSAs on an interface.
Syntax
ip ospf database-filter all out
no ip ospf database-filter all out
no ip ospf database-filter all out
Default Configuration
By default, LSAs are flooded on all interfaces in a routed VLAN.
Command Mode
Interface Configuration mode
User Guidelines
This command is only applicable to OSPFv2 routing configurations.
ip ospf dead-interval
Use the ip ospf dead-interval command in Interface Configuration to set the
OSPF dead interval for the specified interface. Use the no form of the
command to return the interval to the default value.
Syntax
ip ospf dead-interval
seconds
2CSPC4.X8100-SWUM102.book Page 1233 Friday, March 15, 2013 8:56 AM