DELL 8132 ユーザーズマニュアル
OSPF Commands
1249
redistribute
Use the redistribute command in Router OSPF Configuration mode to
configure OSPF protocol to allow redistribution of routes from the specified
source protocol/routers. Use the no version of the command to disable
redistribution from the selected source or to reset options to their default
values.
Syntax
redistribute protocol [metric metric-value] [metric-type type-value] [tag
tag-value] [subnets]
no redistribute protocol [metric] [metric-type] [tag] [subnets]
no redistribute protocol [metric] [metric-type] [tag] [subnets]
Parameter Description
Default Configuration
0 is the tag-value default configuration.
Parameter
Description
protocol
rip - Specifies RIP as the source protocol.
static - Specifies that the source is a static route.
connected - Specifies that the source is a directly connected
static - Specifies that the source is a static route.
connected - Specifies that the source is a directly connected
route.
static
Specifies that the source is a static route.
connected
Specifies that the source is a directly connected route.
metric-value
Specifies the metric to use when redistributing the route.
(Range: 0–16777214)
type-value
Type 1 external route.
Type 2 external route.
Type 2 external route.
tag-value
Value attached to each external route, which might be used to
communicate information between ASBRs. (Range:
0–4294967295)
subnets
Specifies whether to redistribute the routes to subnets.
2CSPC4.X8100-SWUM102.book Page 1249 Friday, March 15, 2013 8:56 AM