DELL 8132 ユーザーズマニュアル

ページ / 1818
1252
OSPF Commands
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
Some of the information below displays only if you enable OSPF and 
configure certain features. The following fields may be displayed:
Field
Description
Router ID
A 32-bit integer in dotted decimal format identifying the router 
about which information is displayed. This is a configured value.
OSPF Admin 
Mode
Shows whether OSPF is administratively enabled or disabled.
RFC 1583 
Compatibility
This configuration option controls the preference rules used 
when choosing among multiple external LSAs advertising the 
same destination. When enabled, the preference rules remain 
those specified by RFC 1583. When disabled, the preference 
rules are those stated in Section 16.4.1 of RFC 2328. These rules 
prevent routing loops when external LSAs for the same 
destination have been originated from different areas.
External LSDB 
Limit
Shows the maximum number of non-default external LSAs 
entries that can be stored in the link-state database.
Exit Overflow 
Interval
Shows the number of seconds that, after entering 
OverflowState, as defined by RFC 1765, a router will attempt to 
leave OverflowState.
Spf Delay Time
The number of seconds to wait before running a routing table 
calculation after a topology change.
Spf Hold Time
The minimum number of seconds between routing table 
calculations.
Flood Pacing 
Interval
The average time, in milliseconds, between LS Update packet 
transmissions on an interface. This is the value configured with 
the timers pacing flood command.
LSA Refresh 
Group Pacing 
Time
The size of the LSA refresh group window, in seconds. This is the 
value configured with the timers pacing lsa-group command.
Opaque Capability Shows whether router is capable of sending Opaque LSAs. 
2CSPC4.X8100-SWUM102.book  Page 1252  Friday, March 15, 2013  8:56 AM