DELL 8132 ユーザーズマニュアル
1336
OSPFv3 Commands
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the information in VLAN 11’s virtual
interface tables.
console#show ipv6 ospf interface vlan 11
IP Address..................................... Err
ifIndex........................................ 1
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 10
(computed)
OSPF Mtu-ignore................................ Disable
OSPF cannot be initialized on this interface.
interface-number
The valid interface number, a valid VLAN ID, tunnel identifier
(Range: 0–7) or loopback identifier (Range: 0–7).
Parameter
Description
2CSPC4.X8100-SWUM102.book Page 1336 Friday, March 15, 2013 8:56 AM