DELL 8132 ユーザーズマニュアル
Routing Information Protocol Commands
1365
Default Configuration
Both is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example allows no RIP control packets to be received by VLAN
11.
console(config-if-vlan11)#ip rip receive version none
ip rip send version
Use the ip rip sent version command in Interface Configuration mode to
configure the interface to allow RIP control packets of the specified version to
be sent. Use the no form of the command to return the version to the default
value.
Syntax
ip rip send version {rip1 | rip1c | rip2 | none}
no ip rip send version
no ip rip send version
• rip1 — Send RIP version 1 formatted packets.
• rip1c — Send RIP version 1 compatibility mode, which sends RIP version
• rip1c — Send RIP version 1 compatibility mode, which sends RIP version
2 formatted packets via broadcast.
• rip2 — Send RIP version 2 using multicast.
• none — Do not allow any RIP control packets to be sent.
• none — Do not allow any RIP control packets to be sent.
Default Configuration
RIP2 is the default configuration.
2CSPC4.X8100-SWUM102.book Page 1365 Friday, March 15, 2013 8:56 AM