DELL 8132 ユーザーズマニュアル

Password Management Commands

The default value is 0. This limit is not enforced unless the passwords 

strength minimum character-classes command is configured with a value 

greater than 0.

Global Configuration

This command is used to enable password character class checking using the 

parameters set by the following commands:

• passwords strength minimum uppercase-letters
• passwords strength minimum lowercase-letters
• passwords strength minimum special-characters
• passwords strength minimum numeric-characters

A value greater than 0 specifies the minimum number of character class tests 

a password must pass. A value of 0 disables the minimum strength checking 

set by the above commands.

console(config)#passwords strength minimum character-classes 4

Use this command to exclude the keyword while configuring the password. 

The password does not accept the keyword in any form (inbetween the string, 

case insensitive and reverse) as a substring. You can configure up to a 

maximum of three keywords. Use the no form of this command to reset the 

restriction for a given string or all the strings configured.

passwords strength exclude–keyword 

string

no passwords strength exclude–keyword [

string]

2CSPC4.X8100-SWUM102.book  Page 1548  Friday, March 15, 2013  8:56 AM