DELL 8132 ユーザーズマニュアル

SDM Templates Commands

On PowerConnect devices, the total available H/W route entries are divided 

statically (at compile-time) among IPV4 and IPv6 routes. If a switch is 

deployed in network environments where no IPv6 routes are needed, then 

H/W resources allocated for IPv6 routes are unused.
The Switch Performance Optimization feature enables the operator to 

optimize resources for IPv4 only routing environments depending on the how 

the switch is used in the network at runtime. The operator can choose 

between Ipv4-only (where all the routing table entries are reserved for IPv4 

Routes) or IPv4/IPv6 (Default) mode.

This chapter explains the following commands:

Use the sdm prefer command in Global Config mode to change the template 

that will be active after the next reboot. To revert to the default template 

after the next reboot, use the no form of this command.

2CSPC4.X8100-SWUM102.book  Page 1577  Friday, March 15, 2013  8:56 AM