DELL 8132 ユーザーズマニュアル

ページ / 1818
System Management Commands
1721
Use the show switch command in User EXEC mode to display information 
about units in the stack. 
The show switch command shows the configuration and status of the 
stacking units, including the active and standby stack management units, the 
pre-configured model identifier, the plugged in model identifier, the switch 
status and the current code version. If there is a stack firmware 
synchronization (SFS) operation in progress, the switch status will show as 
Updating Code. Both the pre-configured switch type (as set by the member 
command in stack mode) and the actual connected switch type are shown.
The show switch 
unitid command shows details of the switch configuration 
including the SFS last attempt status for the specified unit. 
The show switch command may show an SDM Mismatch value in the Switch 
Status field. This value indicates that the unit joined the stack, but is running 
a different SDM template than the management unit. This status should be 
temporary; the stack unit should automatically reload using the template 
running on the stack manager.
Use the show supported switchtype command to display switch SIDs.
Use the show stack-ports command to display details regarding stacking links.
Use the show slot command to display details regarding slot configuration.
Use the show sdm prefer command to display the SDM template 
configuration.
Syntax
show switch [chassis-mgmt | 
stack–member–number | stack–ports[counters 
| diag] | stack–standby]
Parameter Description
Parameter
Description
unitid
The unit number.
chassis-mgmt
Display chassis management.
stack–member–number
The stack member number.
stack–ports
Display summary stack-port information for all interfaces.
counters
Display summary data counter information for all interfaces.
2CSPC4.X8100-SWUM102.book  Page 1721  Friday, March 15, 2013  8:56 AM