DELL 8132 ユーザーズマニュアル
System Management Commands
1739
Syntax
stack-port {fortygigabitethernet|tengigabitethernet}
unit/slot/port {ethernet
| stack}
Default Configuration
By default, Ethernet ports are configured to operate in Ethernet mode.
Command Mode
Stack Configuration mode
User Guidelines
The clear config command will not change the stacking port mode. Only the
stack-port command can change the operating mode of the stacking port and
it only takes effect after a reboot when changing between stacking and
Ethernet mode.
The stack-port configuration mode does not appear in the running config.
The stack-port configuration mode does not appear in the running config.
Use the show switch stack-port command to display configuration and status
of stacking ports. Ports that are configured to operate as stacking ports will
show as detached in the show interfaces status command output.
Use the show switch command to display information regarding the switches
Use the show switch command to display information regarding the switches
in a stack. Fortygigabitethernet ports are only supported on the PC81xx
switches. Redundant stacking links between any two units must operate at
the same speed. A 40G port configured in 4x10G mode is considered to be
operating at 10G speed.
Up to eight stack ports can be configured per stacking unit (four in each
Up to eight stack ports can be configured per stacking unit (four in each
direction).
The PC80xx and PC81xx switches support up to six units configured in a
The PC80xx and PC81xx switches support up to six units configured in a
stack and can utilize 10GBaseT, SFP+ or QSFP (81xx only) connections for
stacking.
Example
console(config-stack)#stack-port tengigabitethernet 1/0/3 stack
console(config-stack)#
2CSPC4.X8100-SWUM102.book Page 1739 Friday, March 15, 2013 8:56 AM