DELL 8132 ユーザーズマニュアル

System Management Commands

Following is an example of using the telnet command to connect to 

176.213.10.50.

console#telnet 176.213.10.50

Esc U sends telnet EL

Use the traceroute command in Privileged EXEC mode to discover the IP 

routes that packets actually take when traveling to their destinations.

traceroute [ ip | ipv6 ] 

ipaddress | hostname [ initTtl initTtl ] [ maxTtl 

maxTtl ] [ maxFail maxFail ] [ interval interval ] [ count count ] [ port port ] 

[ size 

size ][source {<src-ip-address>|vlan <vlan-id>|loopback <loop-

id>}]

ipaddress

Valid IP address of the destination host.

hostname

Hostname of the destination host. (Range: 1–158 characters). 

The command allows spaces in the host name when specified in 

double quotes. For example, console(config)#snmp-
server host "host name"

initTtl

The initial time-to-live (TTL); the maximum number of router 

hops between the local and remote system (Range: 0–255).

maxTtl

The largest TTL value that can be used (Range:1–255).

maxFail

Terminate the traceroute after failing to receive a response for 

this number of consecutive probes (Range: 0–255).

interval

The timeout period. If a response is not received within this 

period of time, then traceroute considers that probe a failure 

(printing *) and sends the next probe. If traceroute does receive 

a response to a probe, then it sends the next probe immediately. 

(Range: 1–60 seconds).

2CSPC4.X8100-SWUM102.book  Page 1744  Friday, March 15, 2013  8:56 AM