DELL 8132 ユーザーズマニュアル

Ethernet Configuration Commands

When both speed and duplex are configured to auto, auto negotiation is 

enabled for the port. To disable auto-negotiation on a port, it is necessary to 

enter both the speed and duplex commands without using the auto 

parameter. Fiber ports do not support auto-negotiation and therefore require 

the operator to enter the duplex full command and the speed 

command with the desired operating bandwidth. Disabling auto-negotiation 

on 1G copper ports may lead to random frame loss as the clock master has not 

been arbitrated by the auto-negotiation process. Auto-negotiation is required 

on 10G/40G copper ports, and is recommended on all copper ports.

The following example configures the duplex operation of gigabit Ethernet 

port 1/0/5 to force full duplex operation.

console(config)# interface gigabitethernet 1/0/5

console(config-if)# duplex full

Use the flowcontrol command in Global Configuration mode to configure 

the flow control. To disable flow control, use the no form of this command.

Flow Control is enabled by default.

Global Configuration mode

This command has no user guidelines.

2CSPC4.X8100-SWUM102.book  Page 407  Friday, March 15, 2013  8:56 AM